Aerospace SOLUTIONS Process automation



Process automation


Both OptiMold and OptiFlow can be used for process automation alone or in combination with additional software.

Both OptiMold and OptiFlow can be used for process automation either alone or in combination with additional software. Both OptiMold and OptiFlow can provide direct feedback to control actuators through their built-in relay outputs. For example both of them can be used to provide an output signal when resin has arrived at the connected sensor to open or close automatically inlet or outlet gates.

In more complicated control cases, OptiMold and OptiFlow can be used in combination with additional software adapted to the specific Materials & Processes e.g. based on the real-time degree of cure prediction to open a press in a RTM or SMC production or to start cooling the oven in a vacuum infusion application.

Other process control actions such as the immediate stop of the production can be decided based on the measured resin aging or the mixing ratio deviations.


Visit us at JEC World in Paris, May, 3 to 5
Synthesites will be exhibiting at Hall 6/ A42

Synthesites and its technologies are mentioned in the largest Composites magazine
Composites World includes our technology in a special article for sensors in Composites

NLR, Synthesites work toward intelligent manufacturing for aerospace structures
NLR acquires fully operational intelligent resin monitoring system for noninvasive, real-time resin viscosity and glass transition temperature estimation.